Views: 123 Author: Site Editor Publish Time: 2026-11-09 Origin: Site
Take a clutch disc and flip it over. Around the hub, you’ll usually see several rings of springs embedded in the disc. Some call them damper springs, others call them torsional springs. The name doesn’t matter much—what matters is that when they fail, the entire drivetrain feels different.
After the engine fires, each cylinder takes turns producing power, so the torque output is not a smooth, continuous flow—it comes in pulses. If those pulses traveled unchanged into the gearbox and rear axle, the gears and bearings would be constantly taking hits.
The springs in the clutch disc are there to absorb those pulses. When torque surges in, the springs compress first, softening the impact before passing it along. They act like a cushion in the drivetrain, making power delivery smoother.
The most typical sign is a “clunk” during take-off or gear changes, like metal hitting metal. This happens because the springs can no longer hold tension, creating play between the hub and the disc body. Torque comes in and out, and the parts knock against each other.
In more severe cases, you’ll hear a rattling noise near the gearbox at idle, which gets quieter or disappears when you press the clutch. Many people assume it’s the release bearing, but when they take it apart, they find the clutch disc springs have come loose.
Another scenario is a spring breaking outright. A broken spring can get wedged inside the disc, scraping as it rotates and making a harsh noise. When that happens, it must be replaced immediately—don’t keep driving.
You don’t need to take anything apart. You can test it by hand.
Pick up a new clutch disc, grip the outer disc with both hands, and use your thumb to twist the center hub so it rotates slightly relative to the outer disc. On a good disc, you’ll feel resistance from the springs, and when you let go, the hub should spring back to its original position.
If it turns too easily and doesn’t return when you let go, the spring preload is insufficient or there’s an assembly problem. If you feel sticking or hear noise while turning, there may be debris inside or the springs may be deformed.
This little test takes about ten seconds, but it can help you weed out obviously defective discs.
BEWO clutch discs use damper springs selected to match the torque rating of each vehicle model—not the same spring for every application. After assembly, preload is checked, and samples are retained from each batch so customers can compare if they have questions.
When wholesalers and repair shops inspect incoming goods, they can try the hand-twist method described above. Give it a turn, let it go, and you’ll have a pretty good idea.
